Radiolink AT10II 12CH RC Transmitter and Receiver R12DS 2.4GHz Spread Radio Remote Controller for Drone Left Hand Throttle Игрушки и - купить

Купить Radiolink AT10II 12CH RC Transmitter and Receiver R12DS 2.4GHz Spread Radio Remote Controller for Drone Left Hand Throttle | Игрушки и

Description:

Type: Radiolink AT10II 10 Channel transmitter set

AT10II Transmitter:

Frequency 2.4 GHz ISM band (2400 MHz to 2485 MHz)

Modulation Mode QPSK

Channel Bandwidth 5.0MHz

Spread Spectrum DSSS, FHSS

Adjacent Channel Rejection > 38dBM

Transmitter Power < 100mW (PCB test), < 20dBm (3 meter air test)

Operating Current < 95mA

Operating Voltage 8.6~15V

Control Distance 800 meters ground

Channel 10 Channel

Simulator Mode Under the simulator model the transmitter action turn off, change to power saving model

Screen 16 colorful screen

Size 78 x 52mm

320*480 pixel

Compatible Model Include all 120 degrees and 90 degrees swashplate helicopter, all fix wing and glider, five flying model.

Size 18 x 9.5 x 22 cm

Weight 0.95 kg

R12DS Receiver:

Frequency 2.4 GHz

Channel 12CH, support SBUS and PWM signal output

Working Voltage 4.8-10V

Working Current 38-45 mA (input voltage: 5V)

Dimension 50x31.5x14.5mm

Weight 14g

Control Range About 4KM Air

(Maximum range testing in unobstructed areas free of interference and may vary depending on local regulations).

Two signal working mode of R12DS:

(1)PWM signal output working mode: red LED indicates PWM signal output, 11 channels Totally.

(2) S-BUS signal output working mode: blue/purple LED indicates S-BUS signal output, 12 channels totally.

S-BUS and PWM signal working at the same time. S-BUS signal channel(3 pin of row 11) output 12 channels S-BUS signal, PWM signal channels(3 pin of row 1 to row 10) output CH3 to CH12 PWM signals, but 12 channel in total. How many PWM signal channels you can use depends on how many S-BUS signal channels you have used(e.g: you have use 4 S-BUS signal channels, then you have 8 PWM signal channels to use).

How to match code with transmitter:

1. Put the transmitter and the receiver close to each other within 1 meters.

2. Turn on the transmitter, then power on the R12DS.

3. Connect CH3 of R12DS to ESC.

4. There is a black button on the R12DS, use a thin stick press the button twice in two seconds, receiver light starts blinking, after about blinking 8 times, match code success and receiver signal LED always on.

Packing list:

1 x Radiolink AT10II 10 Channel transmitter

1 x Receiver

1 x PRM-01 module

Note:Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.